1.
|
Abstrakt: Having new, very powerful tool for stress analysis in form of modem simulation methods as FEM we are able to determine stress and strain state in the examind st [...]
|
2.
|
The contents of the paper is a comparison models of vibration of the cantilever beam with the backstop. The beam model is solved by analytical method and also by using fi [...]
|
3.
|
Krejčí, P.
This paper presents design of intelligent sensor for robotic leg of quadruped experimental robot. Information about contact load as well as direction and magnitude of con [...]
|
4.
|
The method of simultaneous flow velocity and concentration measurement by means of a constant temperature anemometer with two parallel hot wires probe in a binary gas mix [...]
|
5.
|
There are mechatronic applications, where a slender beam or plate is subjected to static magnetic force generated by an electromagnetic actuator consisting of a solenoid [...]
|
6.
|
Recent improvements of infrared thermography cameras allow detecting small defects and hygroscopic salts that are present under the surface of building heritage materials [...]
|
7.
|
The bridges, footbridges and broadcast towers create an important subset of infrastructure subjected to dynamic loading of various origins. Especially, exposed to wind, t [...]
|
8.
|
Hole drilling method is a total numerical simulation of tension or bending loading of two types of beam specimens. The FEM model of the special drilling strain gauge rose [...]
|
9.
|
Abstrakt: The paper deals with evaluation and analyzing of stresses in rubber cylindrical specimen which was twisted up to large deformation. Ogden hyperelastic nonlinear [...]
|
10.
|
In the past decade, the economy of China has been increasing at a remarkable speed, which causes the rapid increase of automobile industry. Researches in past years demon [...]
|
11.
|
American standard ASTM E 837-01 covers the procedure for determining residual stresses by the hole-drilling strain gauge method. This test method is applicable in those c [...]
|
12.
|
This article deals with three different factors which can influence the accuracy of the stress-strain data of elastomers measured with a biaxial testing rig. In terms of [...]
|
13.
|
The composite tube fabricated from elastomer matrix reinforced with NiTi wires was tested within simultaneous inflation and extension. Four different longitudinal weights [...]
|
14.
|
Antoš, P.
The paper deals with the fluid temperature effect on the hot-wire anemometer output signal. There is described a correction method which compensate for fluid temperature [...]
|
15.
|
Paper considers the task of forecasting of individual remaining resource of metal wares of bridge cranes when their life time corresponding to norm is elapsed. Decision o [...]
|
16.
|
Malášek, J.
State of stress identification consists of these parts – of miniaturised pressure sensors in matrix arrangement and of a special strain-gauge bridge – this is a compl [...]
|
17.
|
We present the orthotropic hyperelastic material model for numerical simulation of the loading of the cylindrical membrane. The coefficients of strain energy function of [...]
|
18.
|
This contribution deals with proposal of the method for strain gauge measurements of rubber patterns under dynamic loading. As deform elements the silicon strain gauges w [...]
|
guest ::