000021395 001__ 21395
000021395 005__ 20170522124352.0
000021395 04107 $$aeng
000021395 046__ $$k2017-05-15
000021395 100__ $$aNowakowski, Ł.
000021395 24500 $$aDESIGNATION OF THE MINIMUM THICKNESS OF MACHINED LAYER FOR THE MILLING PROCESS OF DURALUMIN PA6

000021395 24630 $$n23.$$pEngineering Mechanics 2017
000021395 260__ $$bBrno University of Technology, Institute of Solid Mechanics, Mechatronics and Biomechanics, Brno
000021395 506__ $$arestricted
000021395 520__ $$2eng$$aThis article is to present the result of experimental research concerning measurements of the minimum thickness of machined layer to initiate the end milling process of duralumin PA6. The research was conducted in two stages at the laboratories of the Kielce University of Technology. The research required performance of machining tests that involved initiation of the milling process. The gradual initiation of the milling process was achieved thanks to a flowing change of machining depth by tilting the working surface of samples at a slight angle (Fig. 1). The designation of the minimum thickness of machined layer was implemented with the use of a 2D profile that represented the initiation zone of the machining process, which was achieved by measuring the working surface of samples with a skidless contact profilometer TOPO 01P. The results of experiments concerning the impact of feed and cutting speed on the value of the minimum thickness of machined layer have been presented in form of charts. Machining tests were conducted at a numerically controlled machining center AVIA VMC 800 with a milling head CoroMill 490 manufactured by Sandvik Coromant.

000021395 540__ $$aText je chráněný podle autorského zákona č. 121/2000 Sb.
000021395 653__ $$aEnd milling, Minimum thickness of machined layer, Feed, Cutting speed.

000021395 7112_ $$aEngineering Mechanics 2017$$cSvratka, CZ$$d2017-05-15 / 2017-05-18$$gEM2017
000021395 720__ $$aNowakowski, Ł.$$iSkrzyniarz, M.$$iMiko, E.
000021395 8560_ $$ffischerc@itam.cas.cz
000021395 8564_ $$s947110$$uhttps://invenio.itam.cas.cz/record/21395/files/0722.pdf$$yOriginal version of the author's contribution in proceedings, page 722, section MCT.
000021395 962__ $$r21225
000021395 980__ $$aPAPER