000021396 001__ 21396
000021396 005__ 20170522124352.0
000021396 04107 $$aeng
000021396 046__ $$k2017-05-15
000021396 100__ $$aNowakowski, Ł.
000021396 24500 $$aMILLING WITH A TOOL WITH UNEVENLY DISTRIBUTED CUTTING PLATES

000021396 24630 $$n23.$$pEngineering Mechanics 2017
000021396 260__ $$bBrno University of Technology, Institute of Solid Mechanics, Mechatronics and Biomechanics, Brno
000021396 506__ $$arestricted
000021396 520__ $$2eng$$aThis article is to present the results of experimental research and the analysis of recorded signals of relative displacements in the tool-workpiece system during face milling with an endmill will 3 unevenly distributed cutting plates and 6 evenly distributed cutting plates. The measurement stand was prepared on a numerically controlled vertical milling center VMC 800 manufactured by AVIA, with the use of a laser interferometer system manufactured by Renishaw and a measurement track. The processing involved machining of samples made of C45 steel with the use of a CoroMill R245-080Q27-12M cutter with the diameter of Ø80 mm, manufactured by Sandvik Coromant. This article has presented the results of experimental research concerning the influence of asymmetrical and symmetrical distribution of plates in the tool body and the feed velocity on the value of relative displacements in the tool-workpiece system. The results have been presented in form of charts reflecting the relative displacements in the tool-workpiece system, depending on the time, FFT analysis charts (Błasiak, 2016), standard deviation of relative displacements, and feed on the cutting edge.

000021396 540__ $$aText je chráněný podle autorského zákona č. 121/2000 Sb.
000021396 653__ $$aVibrations, Shifts, End milling, Tools with uneven tooth pitch, Feed, FFT analysis.

000021396 7112_ $$aEngineering Mechanics 2017$$cSvratka, CZ$$d2017-05-15 / 2017-05-18$$gEM2017
000021396 720__ $$aNowakowski, Ł.$$iSkrzyniarz, M.$$iMiko, E.
000021396 8560_ $$ffischerc@itam.cas.cz
000021396 8564_ $$s973938$$uhttps://invenio.itam.cas.cz/record/21396/files/0726.pdf$$yOriginal version of the author's contribution in proceedings, page 726, section MCT.
000021396 962__ $$r21225
000021396 980__ $$aPAPER