Contributors:
Publisher:
University of West Bohemia, Plzeň
Citations:
COMPUTATIONAL MECHANICS 2014 - Extended Abstracts, Adámek V., Zajíček M., Jonášová A.(eds), University of West Bohemia, Plzeň, 2014.
ISBN:
978-80-261-0429-2
| A model of wave propagation in homogenized Biot medium with dual porosity
by Rohan, E. |
| Algorithm for chute motion control
by Blekta, J. |
| Algorithmization issues of flat end check method according to EN 13445-3
by Létal, T. |
| An investigation of stochastic resonance using the Fokker- Planck equation and finite element method
by Král, R |
| Analytical periodic solution and stability assessment of Cardan's mechanism
by Dupal, J. |
| Analytical solution of the film flow on the inner surface of the pipe driven by the flow of the wet steam
by Kořista, M. |
| Approximate eigen-solution of linear viscously damped system with vibration absorber
by Hračov, S. |
| Can Laplace law replace more sophisticated analyses of aortic aneurysms?
by Man, V. |
| Comparison of explicit and implicit discontinuous Galerkin finite element methods for steady and unsteady flow problems
by Bublík, O. |
| Comparison of numerical simulation and experiment in case of bending test of composite rectangular tubes
by Kottner, R |
| Comparison study of algorithms based on fully stress design method for discrete optimization of truss, beam and thin shell finite elements
by Pechác, P. |
| Component-wise partitioned finite element method for wave propagation and dynamic contact problems
by Kolman, R |
| Compressible viscous flow in mini channel - experiment and numerical studies
by Hála, J. |
| Computational modeling of liver perfusion - towards a patient specific model
by Lukeš, V. |
| Computational modelling of cavitation in simple geometries, but complex flows
by Rudolf, P. |
| Crack initiation from sharp V-notch tip in the case of out of plane bended specimen
by Štegnerová, K. |
| Crack propagation in welded polyolefin pipes
by Mikula, J. |
| Crack propagation under nonzero mean combined loading
by Janoušek, J. |
| DGM-ALE method for FSI problems
by Feistauer, M. |
| Damage analysis of hybrid composite cell structure
by Had, J. |
| Damage of the boiler collector caused by vibration
by Buzík, J. |
| Database FinLiv - Focus on Manson-Coffin curves
by Lutovinov, M. |
| Direct dynamic response computation of an aircraft structure based on experimentally identified modal model
by Malínek, P. |
| Dynamic cloth model for motion planning simulations
by Beneš, P. |
| Dynamic response prediction of building loaded by traffic vibration, propagated through subsoil
by Makovička, D. |
| Dynamic stability and post-critical behavior of aeroelastic systems
by Náprstek, J. |
| Elastic wave propagation in nonhomogeneous media: A solution using the 2.5D meshless MLPG approach in the frequency domain
by Staňák, P. |
| Estimating material properties of PU foam using genetic algorithms
by Hruš, T. |
| Experimental investigation of deformations in human pelvis
by Lobovský, L. |
| Experimental verification of fatigue state of bridge construction using string tensometric method
by Záruba, J. |
| Explanation of difference between sequentially linear solvers in damage mechanics
by Elias, J. |
| Extended thermomechanical model for NiTi-based shape memory alloys with plasticity
by Sháněl, V. |
| FE implementation of directional distortional hardening model for metal plasticity
by Marek, R. |
| FFT-based Galerkin method for homogenization of periodic media
by Vondřejc, J. |
| Fatigue crack propagation in railway axles
by Pokorný, P. |
| Flow of non-Newtonian fluid
by Křen, J. |
| Foundation for heavy machines
by Šmejkal, J. |
| Fourier and dispersion
by Okrouhlík, M. |
| Fracture mechanics of composite materials - determination and representation of stress coefficient terms
by Kotoul, M. |
| Hard packing for 3D Wang cubes generation
by Šedlbauer, D. |
| Homogenization using boundary element methods
by Lukášs, D. |
| Identification of the directional distortional hardening model on the basis of hysteresis loop
by Parma, S. |
| Identifying parameters of Kohout- Vechet fatigue curve model
by Parma, S. |
| Influence of gripping method in biaxial testing of soft biological tissues
by Slažanský, M. |
| Influence of noise reduction on the propeller performance
by Klesa, J. |
| Influence of soil loading on fracture behavior of multilayer polymer pipe
by Ševčík, M. |
| Influence of the fibre stiffness model in a weightfibre-pulley-drive mechanical system on the coincidence with the experimental measurement results
by Polach, P. |
| Investigation of flow over non-vibrating and vibrating airfoil
by Hamza, J. |
| Isogeometric analysis in free vibration problems
by Kolman, R |
| Linear fiber-based additional measurements of position of serial angular robots
by Adamčík, J. |
| Macroscopic modeling of electro-osmosis in the porous structure of a cortical bone tissue
by Turjanicová, J. |
| Micro-mechanical analysis of fiber reinforced composites with large aspect ratio by meshless method
by Zmindák, M. |
| Modal analysis of beam structures reinforced by partially embedded reinforcing core
by Naď, M. |
| Model identification and control law optimization of fiber driven mechanism QuadroSphere
by Svatoš, P. |
| Model of robot with additional flexible deformation sensing for improved control
by Mráz, L. |
| Modelling and analysis of the 3D FGM beam structures
by Murín, J. |
| Modelling of flexi-coil springs with rubber-metal pads in a locomotive runmng gear
by Michálek, T. |
| Modelling of various phase transformations in ferroic solids, in particular magnetic shape-memory materials
by Roubíček, T. |
| Multibody model of a human body
by Špička, J. |
| Musculoskeletal computer model used for gait analysis of patients with total endoprosthesis
by Havelková, L. |
| Nonlinear vibration and modelling of fretting wear of the nuclear fuel rods
by Zeman, V. |
| Nonlinear vibration of beam-type components with inner impact interaction
by Dyk, S. |
| Numerical homogenization of fibres reinforced composite materials using representative volume
by Smetánka, L. |
| One-dimensional mathematical model of oil extraction process in a continuous screw press
by Voldřich, J. |
| Optimization of counter flow plate heat exchangers
by Dvorák, V. |
| Parametric excitation on the fuel assembly TVSA- T
by Pečínka, L. |
| Phenomenological and physical models of automotive shock absorbers
by Volech, J. |
| Possibility of a rotor-stator contact assessment
by Červená, O. |
| Principles of creation of structured grids for CFD simulations
by Zabranský, T. |
| Problems and solutions connected with the wet/dry interface in the mathematical model of the shallow water equations
by Fišer, M. |
| Representation of crushing phenomenon in DEM model of railway ballast
by Dubina, R. |
| Residual stress distribution in polyolefin pipes
by Poduška, J. |
| Robust method for finding of dispersion curves in a thick plate problem
by Hora, P. |
| Seismic response of piping systems with viscous dampers in nuclear power plants
by Chlud, M. |
| Simulation of an air jet weft pick
by Zák, J. |
| Stability limits of the pre-stressed lightweight material model
by Neusser, Z. |
| Stress and strength analysis of flat samples manufactured from C/PPS pellets
by Padovec, Z. |
| String meters for testing of mechanical functionality of bridges
by Štemberk, P. |
| The additional effects of fluid in a thin gap with a heterogeneous environment
by Krutil, J. |
| The influence of floating rmg bearing parameters on turbocharger dynamic behavior
by Rendlová, Z. |
| Thermo-mechanical finite element analysis of mould for piston casting
by Močilan, M. |
| Thermodynamic loss of condensation in steam turbine cascade
by Šťastný, M. |
| Three filaments model of sarcomere
by Čibera, V. |
| Towards RVE via Wang tilings
by Doškář, M. |
| Updating of aircraft dynamic model according results of ground vibration test
by Čečrdle, J. |
| Usage of the particle swarm optimization in problems of mechanics
by Bulín, R. |
| Vibration attenuation of a periodically loaded system supported by carbon composite bars
by Zapoměl, J. |
| Vibrations of blades couple connected by slip-stick dry friction
by Půst, L. |
| Virtual simulation of traffic barrier
by Kalinský, M. |
guest ::
PDF