1.
|
The method of simultaneous flow velocity and concentration measurement by means of a constant temperature anemometer with two parallel hot wires probe in a binary gas mix [...]
|
2.
|
The paper is focused on comparison of numerical solution and experimental work of the flow field near model of hump. The hump is located in closed measurement area of Eif [...]
|
3.
|
Pavlenko, M. V.
The present article describes the results of research related to vibration wave impact on the coal array and the coal seam in particular, which is used to increase the me [...]
|
4.
|
Antoš, P.
The paper deals with the fluid temperature effect on the hot-wire anemometer output signal. There is described a correction method which compensate for fluid temperature [...]
|
5.
|
Hlaváč, L.
The contribution is aimed at disintegration of hot rocks and rock-like materials by water jets acting in two ways. The first one is bound with penetration of jet to a cer [...]
|
6.
| |
7.
|
A qualitative analysis of influence of cross-flow shear on its interaction with a jet emanating perpendicularly from the wall is presented. The linear shear flow was gene [...]
|
8.
|
Descaling of hot rolled plates is typical application for high pressure flat jet nozzles. Row of nozzles with overlapping area at direction of moving hot plate is usually [...]
|
9.
|
This paper describes a structure of water jet outflowing from the highpressure nozzles. It deals with the flow pattern, the pulsation influence on heat transfer in the im [...]
|
10.
|
Equipments which work on principle of SJ should be found in aerospace industry, in automotive industry, in design of pumps and ejectors, for cooling and heating applicati [...]
|
11.
|
The impact of synthetic jet on the properties of the main jet flowing from an axisymmetric nozzle has been investigated. The examinations were preceded by a theoretical a [...]
|
12.
|
The article deals with measurement of flow parameters in defined 90° bend profiles of square constant cross section and it´s linking upstream and downstream straight ax [...]
|
13.
|
Uruba, V.
Velocity field of a synthetic jet has been investigated experimentally. The synthetic jet is generated by electro-dynamical system designed for control of free shear laye [...]
|
14.
|
Crack problem for an array of collinear cracks in composite matrix, where the cracks tips may terminate at the interfaces of inclusions with the different elastic propert [...]
|
15.
|
The diffusion of the fluid particles is one of the important fundamental problems of the research of transitional and turbulent flows. This phenomena is of great importan [...]
|
16.
|
Tesař, V.
Impinging jets can achieve the highest convective heat or mass transfer rate. An increase beyond present limits is possible by pulsation of the flow. The extreme case of [...]
|
17.
|
Authors investigated an annular synthetic jet required to reach to very large distances while operated at infrasonic frequency. Hot-wire measurements of velocity profiles [...]
|
18.
|
Technique and results of measurement of flow parameters in the channel model of rectangular cross-section with a negative bottom step are presented. The flow was alternat [...]
|
19.
|
Paper deals on an experimental investigation of a synthetic jet array. This investigation focuses on a partial problem of the general task “a synthetic jet array intera [...]
|
guest ::