1.
|
This article deal with problems of cracks in bodies with bimaterial interface. The stress and displacement near the front of crack located at the interface between two or [...]
|
2.
|
So far visualization of the flow, [1] has involved heating the wire with paraffin oil placed across the horizontal axis of the nozzle. The point of the idea of a continuo [...]
|
3.
|
The paper assess a behavior and an impact of the air flow on two hangar buildings. For the first hangar the investigation was carried out using both wind tunnel testing [...]
|
4.
|
Schuster, M.
This paper is a short overview of engineering approach to study rail vehicles aerodynamics and aerodynamic interaction between the trains and vicinity infrastructures. Sh [...]
|
5.
|
This article is concerned with comparison of velocity field size depending on size of the eccentricity in leakage joints of centrifugal pumps. Eccentricity is created by [...]
|
6.
|
Frequency modal and damping characteristics of an aeroelastic model designed for experiments in the wind tunnel are studied. Based on the experimental modal analysis the [...]
|
7.
|
Rozehnal, D.
This paper describes stacionary and nonstacionary measurement of aerodynamic characteristics of the airfoil in low speed wind tunnel on the University of Defence Brno. Fi [...]
|
8.
|
The contribution presents numerical as well as experimental investigations of laminar and turbulent pulsating flow in an initial part of a rigid pipe. The simulations wer [...]
|
9.
|
The paper presents experimental results of the optical measurements of flow field around a fluttering NACA0015 profile elastically supported with two degrees of freedom i [...]
|
10.
|
In deep vertical shafts, it is not possible to use common engineering measurement techniques like e. g. traversing. Therefore the transfer of geodetic networks consists o [...]
|
11.
|
Čečrdle, J.
Submitted paper deals with preparation of the X-DIA aeroelastic demonstrator component wind tunnel tests. Paper is focused to design, analysis and manufacturing of new co [...]
|
12.
|
Kadlec, M.
Polymer composite panels are widely used in aeronautic and aerospace structures due to their high strength vs. weight ratio. The objective of this study is to determine m [...]
|
13.
|
Abstrakt: The small aerodynamic facility with variable gas density, concentration of the airhelium mixture and flow velocity is described. Next the procedure of mixing th [...]
|
14.
|
Paper deals on an experimental investigation of a synthetic jet array. This investigation focuses on a partial problem of the general task “a synthetic jet array intera [...]
|
15.
|
The method of simultaneous flow velocity and concentration measurement by means of a constant temperature anemometer with two parallel hot wires probe in a binary gas mix [...]
|
16.
|
Antoš, P.
The paper deals with the fluid temperature effect on the hot-wire anemometer output signal. There is described a correction method which compensate for fluid temperature [...]
|
17.
|
As CFD (computational fluid dynamics) softwares has been under a great development in the past ten years it seems to be possible to use them for civil engineering applica [...]
|
18.
|
The work deals with numerical solution of 3D viscous steady incompressible flow of air passing through the entrance part of a new wind tunnel for the Aerodynamic Laborato [...]
|
19.
|
The diffusion of the fluid particles is one of the important fundamental problems of the research of transitional and turbulent flows. This phenomena is of great importan [...]
|
20.
|
The paper is focused on comparison of numerical solution and experimental work of the flow field near model of hump. The hump is located in closed measurement area of Eif [...]
|